Videos

A demonstration of the New Focus Picomotor using an interferometer. The Picomotor allows for accurate, minute adjustments that cannot be achieved using a manual micrometer.

A step-by-step setup guide for the New Focus 3501 Optical Chopper, including preparation for breadboard mounting. The 3501 Optical Chopper comes with four wheels, a wheel cover, and a GPIB (IEEE-488) interface.

Learn how to use the LB1005 to lock a Vortex II to a rubidium absorption line in this tutorial. About the LB1005: With a bandwidth of 10 MHz, the Model LB1005 high-speed servo controller makes stabilizing the frequency or amplitude of lasers easy and intuitive. And, unlike competitive products currently available, the Model LB1005 servo controller is a one-box solution--no expensive external chassis required.

The GuideStar™ II provides high-reliability high-precision compensation of laser pointing and position drift using two independent New Focus™ Picomotor™ actuated motorized mirror mounts.

Overview demonstration of setting up a New Focus laser, including connection of the interlock required for all new lasers.

A step-by-step guide to installing different types of actuators on a New Focus manual translation stage.

Learn how to lock or unlock a prism mount by adjusting the leaf spring and vertical pin.

Learn how to setup a Velocity Laser and Controller from New Focus. This video also covers how to change the included 120V fuses for use with 220V.

A simple guide for initial diagnostic for a New Focus 3501 Optical Chopper. To view a step by guide for setting up your 3501 chopper visit http://www.youtube.com/watch?v=1EeESvtmPRA

No! See for yourself in this demonstration of New Focus Lab Jacks. Lab Jacks allow precise vertical adjustments, without swapping your posts or optical mounts.

The model 8742 is a 4-axis open-loop intelligent motion controller/driver that provides a compact and low cost solution for driving New Focus open-loop Picomotors products.

This video covers the front panel functions for the TLB-6700 controller from New Focus.

Use a 1/16" or smaller hex key and the opening on each retaining ring to unscrew from a filter wheel.

Setup and operation of the New Focus Vortex Plus and Vantage tunable lasers with the new TLB-6800-LN controller.

When using a New Focus Opti-Claw mount, remember to engage the locking screw on the side of the mount.

The short video shows how to connect the cables to a FC series stage which is equipped with an iPP intelligent stepper motor.

Learn how to setup the new Vortex Plus laser head from New Focus, a Newport Corporation brand.

The actuator mounts on the Gothic Series stages can be easily reconfigured for left-handed operation. The micrometer block is relocated where the push block is and vise versa. The video shows a micrometer reconfiguration of the 9062-COM stage.